The washers are not efficient and will wear quickly and may potentially affect the accuracy of the force readout.

It rotates on plain washers and is a poor choice for multiple rotations under load. The swivel action of the Enforcer was designed to orient it so you can see the display. Why the Enforcer should not be used for high-speed or multiple rotations: The serial number is laser engraved on the side or back of the device. All units produced ON or AFTER this date are NOT subject to recall. All units indicating a manufacture date prior to 16246XXXXX (manufactured in 2016 on the 246th day of the year) are subject to recall. The three digits following the year of manufacture refer to the day of manufacture during the year. As shown below, the first two digits of the number refer to the year of manufacture. Inspect the 10 digit serial number on your device to determine whether your Enforcer is subject to recall. Identify serial number & manufacturing date on your Enforcer However, please don’t use it that way (see next section).Įnforcer units subject to recall used the epoxy/setscrew combination, which include all units manufactured prior to September 2nd, 2016. This is strong enough that even if used with highly-loaded multiple rotations, it cannot unscrew. We will replace the setscrew with a pin that goes through the aluminum part and into a hole in the steel bolt. But subject to the steel cable twisting as it was being loaded it was not secure enough and the bolt unscrewed. Under normal conditions of orienting the Enforcer the bolt would not come out.

The bolt is secured with epoxy and a setscrew, but our examination showed that there should have been more epoxy on the bolt thread. The Enforcer is assembled in a special room on its own assembly line, due to the electronics. As the cable was loaded it unwound, twisting the Enforcer’s swivel eye and the friction generated unscrewed the bolt holding the swivel and it came apart. In addition to the safety modification, we will calibrate your Enforcer for free (normal cost is $100) and send it back with a free carabiner.Ī user had an Enforcer connected to a steel cable, or wire rope. We will do everything we can to ensure that this recall causes the least amount of inconvenience to our customers. This recall is to improve the security of the swivel eye and to issue new user instructions specifying that the Enforcer swiveling action is for orientation, not high speed or multiple rotations. This was discovered due to an incident that occurred. The swivel eye on some Enforcers may not be secure and in certain conditions might unscrew. Online Return Form (Canada & US customers only) Safety Recall for the Enforcer (with expanded lot numbers) Download a hard copy of the Enforcer Recall document (PDF):ĭownload a revised copy of the Enforcer Tech Notice (PDF):Ĭustomers in North America should click here:

Pdf rotator serial number